How to install the safety tether to your Fly6 CE

Modified on: 2018-05-22 09:17:29 +0800


On the back of the Fly6 CE are two rubber plugs covering the holes for the safety tether. 


Push a pin or end of a paper clip through the open holes to loosen the plug, and remove either the left or right plug.


Thread the thinner part of the tether through the hole, then thread the other end through the loop to secure the

tether.


 Reinstall the rubber plug back to the hole and push tightly.


Did you find it helpful? Yes No

Can you please tell us how we can improve this article?