A bench test will allow you to see how your unit performs. To do this, please do the following:

• Check your SD card
  • SD card should be a Class 10 microSD card
  • Check the list of recommended SD cards at cycliq.com/sdcards
• Ensure your Fly6[v] is fully charged
• Reformat your SD card using the instructions here
• Make sure the firmware is up to date. Instructions can be found here
• Disable Idle Mode
  1. Connect your device to your computer
  2. Open the Config.txt file
  3. Change "0" to "5" in your Fly6 Config.txt file (note Be sure to put enable this after the test by switching it back to "0")
  4. Save changes and disconnect

Performing a bench test

When you are ready, place the unit on top of a flat surface and turn it on. Take note of what light settings you are using. You may turn the LED lights off if you want to check how long the battery lasts in default mode. Also, please note what time you started the test.

Leave the unit until it turns off. Once the bench test is done, plug the unit into your computer and open the DCIM and Fly6 folder. Check the time of the last recording and verify. 

If your Fly6[v] is not performing to expectations, please take a screenshot of the video logs (showing the file sizes, date and time) and submit a ticket with our support team here.